Electric Models - RC News

Bleriot II

Bleriot III slow flyer is an great indoor (r/c) radio control model slow flyer using micro feather hs55 or nes-371 servo and receiver.

The original "Slow Flyer" The stuff dreams are made of! You NEVER flew anything like the Bleriot II "Slow Flyer".

The model is very light, only 6 or 7 ounces, but it has a 50" wingspan and huge 483 sq. inch wing area with a very high lift and low speed airfoil. You should fly it when there's no wind or even fly it indoors because flying speed is only about 4 mph! Flying speed is so slow that Bleriot II can easily land and STOP on a card table -- or on your hand! It can turn around in flight in just 10 feet of airspace!

It is made of hand-cut balsa wood with light fabric covering. With the 7.2V 110mah nicad pack 5 minute flights are possible. Bleriot II requires a micro receiver and 2 micro servos (rudder and elevator) and a micro motor controller. While it's very easy to fly and the airframe is assembled and covered, it does require careful installation of the micro servos and the "pull-pull" control connections.

  • Wingspan: 1220mm
  • Flying weight: 200g
  • Motor, gearbox, propellor: Supplied
  • Rudder & Elevator control
  • Required: 7.2V110mAh nicad · 2 x micro servos (JR NES-371 or E151) · Micro receiver (JR R500) · Micro speed control (Schulze slim 08)
Bleriot II - The original "Slow Flyer" The stuff dreams are made of! You NEVER flew anything like the Bleriot II "Slow Flyer".  Bleriot II - The original "Slow Flyer" The stuff dreams are made of! You NEVER flew anything like the Bleriot II "Slow Flyer".
 
www.greatmodeldeals.com  Add Link Resources